Atag HL3011A Manuale Utente Scaricare il pdf (Pagina 10)

10

Cleaning and maintenance of

Stainless steel surfaces

Clean the appliance after use with a

soft cloth well wrung out in warm

water, use a small amount of liquid

detergent for stubborn soiling.

Stainless steel parts may become straw

coloured with use, use a proprietary

stainless steel cleaner to remove this

straw discolouration.

Never use metal wool, metal sponges

or other abrasive cleaning agents.

The ceramic glass hob

Immediately scrape off stains caused

by food which has boiled over using

the scraper supplied with the hob,

spilled sugar, dishes containing sugar

(jam, juice, etc.), melted plastic and

aluminium foil while the ceramic hob

is still hot. If the ceramic hob is

allowed to cool it may become

damaged. A dirty ceramic hob

decreases the heat transfer between

cooking zones and cookware.

After use the cooking zones should be

wiped with a damp cloth with washing

up liquid. For severe soiling you can

follow these steps:

1. Remove stains etc., with the

ceramic hob scraper.

2. Make sure that the ceramic hob

has cooled down. Use a ceramic

cleaning agent, such as vitroclen.

3. Wipe the ceramic hob clean with

a damp cloth or kitchen roll.

Tough stains can be removed by

rubbing the stain hard with

kitchen roll.

4. Wipe off remaining cleaning

agent with a damp cloth.

5. Wipe with a dry cloth, if

required.

Make sure that the ceramic hob is dry

when you heat it up again. Ceramic

hobs can develop rainbow-like stripes

if heated while damp.

15

The electrical connection may only be

performed by a qualified electrician/

competent person. The electrical

connection must be carried out in

accordance with prevailing regulations

for appliances using heavy current.

The connection must comply with any

specific requirements specified by the

local electricity supply authority.

There must be no interference with

any of the unit’s electrical parts.

The cable is mounted in the pegs as

shown.

Unscrew the cover while connecting

the cables.

A unit led directly to the power point

or the outlet rose.

More units may be connected via one

or more junction boxes.

The cable must be connected via an

external switch with a contact

separation of at least 3 mm in each

pole.

Please observe these instructions,

otherwise the warranty will not

cover any damage that may occur.

Single-phase zero-earth

Cable type 1,5 mm² HO5VV-F.

The cable outside diameter must be

between 7,5 and 10,5 mm.

Cover

Electrical installation

1 2 ... 5 6 7 8 9 10 11 12

Commenti su questo manuale

Nessun commento